spring kit


This blogpost was published on 2012-10-17 at

This is an archive.

Available at:

This is a simple spring kit for the extruder pusher:

Many people have trouble finding the right spring for the job, so
I decided I will offer the exact same springs, that I use on my own machine.
I settled to this spring after trying out more then 20 different springs.

The ideal spring is small, stiff, but not too hard to compress,
so the hobbed bar (hyena) does not bite into the filament instantly.

Also when you change the filament, the bolt is long enough so you do
not need to take it out completely from the extruder pusher.

Curious enough, how it looks mounted?:), here we go:

Go grab one!:

I closed down the commenting on this webpage due to the enormous number of penis enlargement suggestions.

If you have any thoughts to share about this article, please discuss it on's mailing list,
in this thread.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-NonCommercial-NoDerivs 3.0 License