Molex connector assembly

version: v3.0.1.

Cut all 4 wires to the same length:
flickr:5170860743

Strip the end of all wires:
flickr:5171465686

Take a soldering iron:
flickr:6362273197

Wet the tips of the wires with solder:
flickr:5170868393

Remove any solder blobs from the ends of the wires.

Wet the molex connector's pins with solder:
flickr:5170868387

Take the supplied heat shrink tubing:
flickr:6362155601

Cut it into four and slide a short length of heat shrink tubing onto each wire, and solder the wires to the molex connectors.
With a match or other heat source, heat the heat shrink tubing to finish the hot-end.
flickr:5171472470italic text

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-NonCommercial-NoDerivs 3.0 License