Arcol.hu Hot-end v3.0 Skeinforge finetunings for 0.35mm nozzle

Introduction

Please see the 0.5mm manual for setting up skeinforge. This manual only lists the difference.

Skeinforge

Craft->Carve->Layer Thickness(mm): 0.25
Craft->Speed->Flow Rate Setting (float): 160 (or 150)

I also raised the temperature, maybe it is good idea for 0.5mm nozzle too, for better plastic flow.
Some people even print abs at 265C! (but not with this hot-end)

Craft->Temperature:
flickr:5215609133

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-NonCommercial-NoDerivs 3.0 License