hot-end firmware modifications


We use the exact same thermistor what Rapman uses. So for Rapman no modification needed on the software side.

Standard Reprap (Mendel) electronics

Please refer to the thermistors pages(100k, 200k).

The current (2011-06-22) advised software configuration for Mendel:

0. Sprinter firmware

Kliment's Sprinter firmware (based on Tonokip firmware) has the 200k temptable built in:

Please uncomment the relevant 200k lines (currently: 133, 134 lines)

1. you put skeinforge in the same directory then printrun
2. you launch (in Printrun)


Makerbot electronics

Pretty please someone update the up to date info on makerbot.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-NonCommercial-NoDerivs 3.0 License